Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
[] Switching
Each Mode
Youcaneasily switchwith the remotecontrol t othe DTV(ATSC) andTV
(NTSC) o rto access a n externaldevice whentheyareconnected tothe unit.
[] Switching
Audio
Mode
Thissection describes h owto switch the audioin theanalogmodeandhow
toswitchthe audiolanguage in the digitalmode.
Press [INPUT]
repeatedly
to cycle through
input
modes.
[ANALOG
MODE]
INPUT
[DIGITAL MODE]
[VIDEO1]
4
[VIDEO2]
• To use the video or S-video input jack on the unit,
select'VIDEO1".
• To use the component
video input jack on the unit,
select'VIDEO2".
While receiving
an MTS broadcast,
press [AUDIO]
repeatedly
to cycle through
the available
audio
channel.
AUDIO
IT:MAIN]
[_ONO]
MAIN
: Outputs
main-audio
SAP
: Outputs
second audio program
MONO
: Outputs
mono-audio
•The information
display will automatically
disappear
in a few seconds.
Note:
• When you switch the analog mode to the digital mode,
it may take a while until the digital channel selection is
completed. The following TVscreen is displayed while
switching the mode.
NOWSCANNING
Press [AUDIO]
to display the currently
selected
language
and the number
of available
languages.
AUDIO
2
Press [AUDIO]
repeatedly
to cycle through
the available
audio languages.
AUDIO
• Available
languages
differ depending
on the
broadcast. "OTHER" is displayed
when the audio
language
cannot
be acquired,
or the acquired
languages
are other than English, Spanish or French.
• The information
display will automatically
disappear
in a few seconds.
Note:
• Pressing [AUDIO] does not control external audio device.
EN
Publicidad
Tabla de contenido
