Masterbuilt 20077515 Manual De Uso página 16

Tabla de contenido

Publicidad

IMPORTANT FACTS ABOUT USING SMOKER
• Maximum temperature setting is 275°F (135°C).
• Do NOT move unit across uneven surfaces.
• Rear handle is NOT for lifting.
• Wood chip loader and wood chip tray MUST be in place when using smoker. This minimizes the
chance of wood fl are ups.
• Wood chips must be used in order to produce smoke and create the smoke fl avor.
• Check grease tray often during cooking. Empty grease tray before it gets full. Grease tray may need to
be emptied periodically during cooking.
• Do not open smoker door unless necessary. Opening smoker door causes heat to escape and may
cause wood to fl are up. Closing the door will re-stabilize the temperature and stop fl are up.
• Do not leave old wood ashes in the wood chip tray. Once ashes are cold, empty tray. Tray should be
cleaned out prior to, and after each use to prevent ash buildup.
• Glass in door is tempered and will not break under normal operation.
• This is a smoker. There will be a lot of smoke produced when using wood chips. Smoke will escape
through seams and turn the inside of smoker black. This is normal. To minimize smoke loss around
door, door latch can be adjusted to further tighten door seal against body.
• Opening smoker door during cooking process may extend cooking
time due to heat loss.
• When outside temperature is cooler than 65°F (18°C) and/or
altitude is above 3,500 feet (1067m), additional cooking time may
be required. To ensure that meat is completely cooked use a
meat thermometer to test internal temperature.
• To adjust door latch, loosen hex nut on door latch. Turn hook
clockwise to tighten as shown. Secure hex nut fi rmly against
door latch.
HOW TO CLEAN SMOKER
For grate supports, smoking racks, water bowl and drip pan use a mild dish detergent. Rinse and dry
thoroughly.
For wood chip tray and wood chip loader, clean frequently to remove ash build up, residue and dust.
Dispose of cold ashes by placing them in aluminum foil, soaking with water and discarding in a
non-combustible container.
For the interior, glass in door, meat probe, and exterior of smoker simply wipe down with a damp cloth. Do
not use a cleaning agent. Make sure to dry thoroughly.
Door seal and inside seam that seal attaches to MUST be cleaned with a damp cloth after each use to
keep seal in proper working condition.
ALWAYS MAKE SURE UNIT IS UNPLUGGED AND COOL
TO THE TOUCH BEFORE CLEANING AND STORING.
15
NO DEVUELVA AL ESTABLECIMIENTO MINORISTA para solicitar asistencia en el montaje de la
unidad, o para reclamar partes faltantes o dañadas.
¡PARE!
Llame al: Departamento de Servicio al Cliente de MASTERBUILT al: 1-800-489-1581
Tenga a la mano los números de modelo y serie cuando llame.
Estos números se ubican en la etiqueta plateada en la parte posterior de la unidad.
LISTA DE PARTES
27
19
18
20
24
(L)
(R)
(R)
(L)
21
29
23
28
14
11
NO DE
CANT DESCRIPCIÓN
PARTE
1
1
Cuerpo del ahumador
2
1
Panel de control
3
1
Asa posterior
4
4
Rejilla para ahumar
5
1
Defl ector de goteo
6
4
Soportes de la rejilla
7
1
Seguro de la puerta
8
1
Tazón de agua
9
1
Bandeja de trozos de madera
10
1
Bandeja de goteo
11
2
Pata ajustable con tornillos
12
1
Cargador de trozos de madera
13
1
Bandeja de grasa
14
2
Ruedas
15
1
Elemente
3
1
2
25
6
26
17
7
16
8
15
13
12
9
22
NO DE
CANT DESCRIPCIÓN
PARTE
16
1
Carcasa de trozos de madera
17
1
Sonda de carne
18
1
Regulador de aire
19
1
Puerta con ventana
20
1
Asa de la puerta
21
1
Pata delanteras (R)
22
2
Abrazadera de la bandeja de grasa
23
1
Panel lateral (R)
24
2
Bisagra de la puerta
25
1
Carcasa del panel de control
26
1
Luz LED
27
1
Control remoto
28
1
Panel lateral (L)
29
1
Pata delanteras (L)
4
5
10
4

Publicidad

Tabla de contenido
loading

Tabla de contenido