Safety Information - Xylem JABSCO NEMP 40/4 Manual De Instrucciones

1. INTRODUCTION
GB
For applications requiring safe, leak-free, continuous
duty pumping. Designed specifically for Marine
& Industrial markets. Typical applications include
marine air conditioner circulation, ice makers, hot
water circulation, livewell or bait tank installations.
2. SYMBOLS IN THIS INSTRUCTION BOOK
Throughout this Instructions book the following
symbols are shown which identify conditions that
pose a hazard to the user or to identify actions
that should be observed. These symbols are also
shown on the product or its packaging. When a
symbol is shown next to a paragraph or statement
it is recommended the user takes particular note
of that instruction in order to prevent damage to
the equipment or to prevent injury to one's self and
other people.
The Responsible Body and the Operator should read
and be familiar with this Instructions book in order
preserve the protection offered by the equipment.
To prevent injury or equipment damage it is the
manufacturer's recommendation that all products
should be fitted by a suitably trained person.
SYMBOLS DEFINED
Caution, risk of danger. See note or adjacent
symbol
Caution / risk of electric shock
Recyclable Packing Material
Do not dispose of product in normal domestic
waste.

3. SAFETY INFORMATION

Prior to installation or use, read this installation
and operating instructions. Installation and
operation must comply with local regulations
and accepted codes of good practice.
Only used with specified products. DO NOT USE
WITH LIQUIDS WITH A FLASH POINT BELOW 100°F
(38°C) OR USE WHERE FLAMMABLE VAPORS ARE
PRESENT. This product has been designed for safe
operation when used as detailed in accordance with
the Manufacturer's instructions.
This manual also contains necessary information for
the correct installation and use of the wireless remote
control. This manual was developed for qualified
personnel with suitable training and technical
qualification to operate this type of equipment.
NOTE: Failure to use this equipment in accordance
with the manufactures operating instructions may
compromise your basic safety protection afforded
by the equipment and may invalidate the warranty /
guarantee. The warranty / guarantee does not cover
damaged caused by faulty installation or misuse of
the equipment.
If the recommended safety notices are not strictly
observed, it can lead to serious or fatal injuries
of personnel and/or material damage. Failure to
observe the recommended safety procedures can
lead to material damage.
All electrical work must be performed by a qualified
technician. Always follow the National Electrical
Code (NEC), or the Canadian Electrical Code, as
well as all local, state and provincial codes. Code
questions should be directed to your local electrical
inspector. Failure to follow electrical codes and
OSHA safety standards may result in personal
injury or equipment damage. Failure to follow
manufacturer's installation instructions may result
in electrical shock, fire hazard, personal injury or
death, damaged equipment, provide unsatisfactory
performance, and may void manufacturer's warranty.
• Only qualified Service personnel should attempt
to repair / service the product.
• Do not cover product (ESPECIALLY VENTILATION
SLOTS) whilst in use.
• Do not run the machine without appropriate
piping attached.
• Do not run the machine without suitable
supervision as established for safe working
practices and company procedures.
• Not to be used by children and non-authorized
personnel.
• Please keep this manual safe and available to all
operators.
• Follow legislation applicable to your areas of
operation.
• Do not touch the motor surface during or after
operation of the pump as the surface can become
hot.
• Only use Original Equipment Manufacture's Parts
and Accessories.
• The equipment is not spark, flame or explosion
proof and has not been designed for use in
hazardous areas in terms of the ATEX Directive
94/9/EC.
• Keep all wire connections above the highest water
level. Wire connections should be sealed with a
marine gland sealant to prevent wire corrosion.
• Disconnect power from the system before
working on the unit to avoid personal injury,
damage to surrounding environment and/or
damage to the unit.
• WARNING: all marine pumps discharging
overboard must be installed with overboard
discharge well above static and heeled waterlines.
Flooding and death may occur