Initial Setup; Power Sources; Charging The Battery Pack; Aa Battery Operation - Eton FR400 Manual Del Propietário

INITIAL SET UP
1. Open the compartment; it slides downward with firm pressure at
center of hinge.
2. Connect the battery pack.

POWER SOURCES

1. Rechargeable battery pack (included).
2. 3 AA batteries (not included).
3. AC adapter/charger (included).
4. Continually turning the crank, even with no batteries installed.

CHARGING THE BATTERY PACK

1. Switch the BATTERY/DYNAMO-ADAPTER/OFF switch to the OFF
position.
2. Turn the dynamo-crank clockwise or counter-clockwise about 2
turns per second for 90 seconds.
3. After charging, select the DYNAMO-ADAPTOR position for power.
While charging, the red LED charging light illuminates.

AA BATTERY OPERATION

1. Open the battery compartment.
2. Install 3 AA batteries, observing polarity diagram.
3. For power, set the power selector switch to the
BATTERY position.
4
FR400 OWNER'S MANUAL