4200 Series Dovetail Jig Overview; Assembly; Height Adjustment - Porter Cable 4210 Manual De Instrucciones

ACCESSORY KITS
4211
1
5 4 3
10
9
1. Half-blind & Sliding Dovetail
Template
2. Brackets (2)
3. Dado Depth Bracket
4. Half-blind Depth Bracket
5. Dovetail Bit
6. Depth Knob
7. Screws (8)
8. Hex Nuts (1)
9. Wrench
10. Template Guide and Lock Nut

ASSEMBLY

The 4200 series dovetail jigs come fully assembled from the factory. However, the accessory templates (4211, 4213,
4215) require assembly. The supplied hex wrench can be used to attach the brackets and router bit depth guides
to the template. A 3/8" wrench is required to adjust the height of the router bit depth guide.
ASSEMBLED JIG
NOTE: Before setting your router bit to depth, the depth stop should be set at 3/8" below the bottom of the template,
as shown above. This is true for all templates.
1
5 4
2
6
6
7
9
8
1. Through and Box Joint
Template
2. Brackets (2)
3. Half-Blind Depth Bracket
4. Straight Bit
5. Template Guide and Lock Nut
6. Hex Nuts (1)
7. Screws (6)
8. Depth Knob
9. Wrench
4213
3 2
7
8
1. Miniature Half-blind, Through, &
2. Brackets (2)
3. Template Guide and Lock Nut (2)
4. Half-blind Depth Bracket
5. Offset Guide (2)
6. Depth Knob
7. Dovetail Bit
8. Straight Bit
9. Hex Nuts (1)
10.Screws (6)
11.Wrench

HEIGHT ADJUSTMENT

8
4215
1
5 4 3
6 7 8
9
Box Template
3/8"
2
10
11