Wiring Diagram; Commissioning; Operation And Use; User Interface - Sime ECOMAXI 260 ErP Manual De Instalación, Uso Y Mantenimiento

5.7

Wiring diagram

Fig. 15 – Wiring diagram

6 Commissioning

WARNING:
appliance has been connected
to the earth wire.
WARNING: check that the mains
voltage corresponds
voltage shown on the appliance
data plate.
To commission the appliance, proceed as
follows:
 Fill the boiler using the inlet valve and
check that there is no leakage from the
gaskets and connectors. Tighten the bolts
or connectors where necessary;
 Do not exceed the maximum pressure
specified under
data";
 Check that the safety devices in the
hydraulic circuit are functioning;
Probe 1: upper probe
Probe 2: lower probe
Probe 3: evaporator probe
check that the
to the
"general technical
DOCUMENT 6328408
Installation, use and maintenance manual
 Connect the plug to the power socket;
 When the plug is plugged in, the boiler is
in stand-by mode, the display is off and
the ON button lights up;
 Press the ON button (see section 7.1.3)
and the appliance is activated in ECO
mode (factory default), 5 minutes after
the button has been pressed.

7 Operation and use

The product is managed through a user
interface which allows you to:
 set the operating mode;
 change the operating parameters;
 view and manage any alarms;
 check the status of the resources.
Hereinafter,
should be understood as the
passage from stand-by mode to
ON mode,
"switching
understood as the passage from
ON mode to stand-by mode.
Hereinafter, the term "advanced
procedure"
understood
specific appliance procedures
as described in the "advanced
set-up" section.
7.1

User interface

The user interface (Fig. 16) allows you to
check and adjust appliance operation. It is
equipped with a display and the following
buttons:
 On/Stand-by button;
 SET button;
 DOWN button;
 UP button.
"switching on"
and the term
off" should be
should be
as referring to
59