Maintenance And Cleaning; Resetting Safety Devices - Sime ECOMAXI 260 ErP Manual De Instalación, Uso Y Mantenimiento

8 Maintenance and cleaning

WARNING: any repairs to the
appliance must be carried out by
qualified technicians. Incorrect
repairs may put the user at
serious risk. If your appliance
needs any kind of repair, please
contact the support service.
WARNING: before performing any
maintenance work, ensure that
the appliance is not connected
to the electric power supply and
that there is no risk of this
accidentally happening. For all
maintenance
please disconnect the electric
power supply.
8.1

Resetting safety devices

The appliance is equipped with a safety
thermostat. This manual-reset device is
tripped by overtemperatures.
To reset the protective device:
 Disconnect the appliance from the
electric power supply;
 Remove any air ducts (see section 5.2);
 Remove the top cover, first unscrewing
the screws holding it in place (Fig. 18);
 Manually reset the safety thermostat
from above (Fig. 19). If the device is
tripped, the central
thermostat protrudes by approximately 4
mm.
 Refit the top cover.
and cleaning,
pin on the
DOCUMENT 6328408
Installation, use and maintenance manual
Fig. 18 – Removing the top cover
Fig. 19 - Resetting the safety thermostat
WARNING: the safety thermostat
may be triggered by a fault in the
control board or by a lack of
water in the tank.
WARNING:
present for
compromises safe operation of
the appliance.
defective parts
spares.
NOTE: if the
triggered, the electrical resistor is
excluded, but the heat pump
can still run within the permitted
operating limits.
Click
Repairing parts
safety reasons
Only replace
with original
thermostat is
73