Statement Of Use; Operating Mode - Desoutter ECPL Serie Manual De Uso

6159934570
Issue no: 09
Series: -
Original instructions.
© Copyright 2019, Ets Georges Renault
44818 St Herblain, FR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.

STATEMENT OF USE

Tool suitable for industrial environment only. It
shall be used for tightening or loosening joints in
wood, metal or plastic material. No other use will
be permitted. For professional use only.
The suspension bail had been designed for
vertical use of the screwdriver. For any other
use, it is recommended to add the accessory P /
N 6153979200 (retainer).
DATA
(See page 3-5).
Sound pressure level:
● < 70 dB(A) (EN 60745-2-2).
● Uncertainly: 3dB(A).
Vibration value:
● < 2.5 m/s² (EN 60745-2-2).
Declaration of noise and vibration emission
All values are current as of the date of this
publication. For the latest information please visit
cp.com.
These declared values were obtained by
laboratory type testing in accordance with the
stated standards and are suitable for comparison
with the declared values of other tools tested
in accordance with the same standards. These
declared values are not adequate for use in risk
assessments and values measured in individual
work places may be higher. The actual exposure
values and risk of harm experienced by an
individual user are unique and depend upon
the way the user works, the workpiece and the
workstation design, as well upon the exposure
time and the physical condition of the user.
We, Chicago Pneumatic, cannot be held liable
for the consequences of using the declared
values, instead of values reflecting the actual
exposure, in an individual risk assessment in
a work place situation over which we have no
control.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
An EU guide to managing hand-arm vibration
can be found at http://www.pneurop.eu/uploads/
documents/pdf/PN3-02-NV_Declaration_info_
sheet_0111.pdf
We recommend a programme of health
surveillance to detect early symptoms which
may relate to noise or vibration exposure, so
6 / 32
that management procedures can be modified to
help prevent future impairment.
REQUIREMENTS
These tools need to be used with controllers
from Desoutter range.

OPERATING MODE

Fit the tool with a suitable fastening accessory,
then connect it to the power supply by means of
the controller.
Select the appropriate program on the controller.
Hold the tool by means of the handle and apply
to the fastener to be tightened.
In manual mode, the motor will start only when
the trigger is operated.
For a reverse rotation, press the reverse button
and apply the tool to the fastener.
As the reaction force increases in proportion to
the tightening torque, make sure that the tool
is in perfect working order and the controller
is programmed correctly, to reduce the risk of
injury to the operator as a result of unexpected
behaviour of the tool.
The stall bar must be installed on
the ECP40S tool before tightening or
loosening.
Refer to the diagram explaining how to
use it.
Be careful not to catch your fingers
between the stall bar and the obstacle
used for the torque control.
01/2019