Statement Of Use; Getting Started - Desoutter ELRT025-P4600-10S Manual Del Usuario

6159939060_07
Series: D
Original instructions.
© COPYRIGHT 2014, DESOUTTER HP2
7SJ UK
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.

STATEMENT OF USE

Tool suitable for industrial environment only. It
shall be used for tightening or loosening joints in
wood, metal or plastic material.
No other use permitted.
For professional use only.
DATA
See page 5.
Working temperature: 0 / +40°C.
Humidity ratio: 0 / 90%.
Declaration of noise and vibration emission
See page 124.
Vibration levels.
Sound levels.
: Vibration levels.
a , a
hd h
K / K = K
pA WA
L
: Sound pressure level.
pA
L
: Sound power level.
WA
All values are current as of the date of this
publication. For the latest information please visit
www.desouttertools.com.
These declared values were obtained by
laboratory type testing in accordance with the
stated standards and are suitable for comparison
with the declared values of other tools tested
in accordance with the same standards. These
declared values are not adequate for use in risk
assessments and values measured in individual
work places may be higher.
The actual exposure values and risk of harm
experienced by an individual user are unique
and depend upon the way the user works,
the workpiece and the workstation design, as
well upon the exposure time and the physical
condition of the user.
= 3 dB: Uncertainty.
We, Desoutter, cannot be held liable for the
consequences of using the declared values,
instead of values reflecting the actual exposure,
in an individual risk assessment in a work place
situation over which we have no control.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
An EU guide to managing hand-arm vibration
can be found at http://www.pneurop.eu/uploads/
documents/pdf/PN3-02-NV_Declaration_info_
sheet_0111.pdf
We recommend a programme of health
surveillance to detect early symptoms which
may relate to noise or vibration exposure, so that
management procedures can be modified to help
prevent future impairment.

GETTING STARTED

ELRT25 tool is to be used with CVIL II controllers
from Desoutter range. The controller firmware
version must be 3.6B9 as a minimum.
● Refer to the CVIL II user manual
at http://resource-center.
desouttertools.com (No login/
password required)
The setup will mainly depend on the joint
hardness and the targeted accuracy.
A pulse tightening is made of two phases:
- a Run down speed phase (continuous)
- a Final speed phase (pulse).
The Run down speed has an impact on the first
peak amplitude.
The Pulse amplitude defines the pulse power. It
has an impact on the torque step between two
consecutive pulses.
Target
torque
Pulse amplitude
Pre-tightening
speed
16 / 128
English
07/2014