Connection Of Elvox Flashing Light Type Ela3 (Supply Voltage 230V) To Courtesy Light Terminal; Initial Operation; Connecting The Operator System; Overview Of The Control Unit - Vimar ELVOX RS14 Manual Para El Conexionado Y El Uso

2.1

Connection of ELVOX flashing light type ELA3 (supply voltage 230V) to courtesy light terminal

Important!
To prevent damaging the insulating sheath of the electrical cable, always lay the cable so that it is not in contact with the courtesy light bulb.
• Remove the courtesy light guard.
• Connect the flashing light.
• Set the desired function (level 3, menu 1).
• Refit the courtesy light guard.

3. Initial operation

3.1 Connecting the operator system

3.2 Overview of the control unit

Operating elements:
A (+) button (e.g. to drive the door to the OPEN position or to increase parameters when programming)
B (-) button (e.g. to drive the door to the CLOSED position or to decrease parameters when programming)
C (P) button (e.g. to switch to programming mode or to save parameters)
16
Terminal block at rear of motor
L1 N
LED displays
1 Photocell (only lights up if the photocell beam is interrupted)
2 Door OPEN position
3 Intermediate position
4 Door CLOSED position
5 Check reference point
6 Has no function
7 Impulse signal (remote control, external control elements)
8 Operation
EN