Wiring; Installation Procedure - koban KDP-DALI 01 Manual De Instrucciones

Wiring (See FIG.5)
Slave detector

Installation procedure

Ceiling flush mounting
To install detector, please drill a hole in diameter of 65mm on ceiling board
and keep the power cable outside. Please strip off 6 - 8mm of cable
sheathing for wiring (See FIG.6).
Drill a hole with
Φ=65mm on the
ceiling
Use screwdriver to loose two screws to take down the protection
cap and take out the cable clamp from it.
Break the rubber gasket, then feed cables through it (See FIG.7).
www.grupotemper.com
Detector de presença para controlo de iluminação DALi
KDP-DALI 01
Botão (NA)
Φ=65
Cable clamp
DALI LED Driver or Ballast
Light
Source
FIG.5
6 - 8mm
30 - 35mm
FIG.6
Non-dropping
screw
Rubber gasket
Protection cap
FIG.7
KDP-DALI 01
Instructions manual | 35