KDP-DALI 01
Presence detector for DALi lighting control
Button
DA1 or DA2 setting selection
•
By pressing "
corresponding value setting.
•
By pressing "
corresponding value setting.
•
The settings for "
channel.
Set delay off time of DA1 / DA2
Under unlock mode, press "
channel for value setting. Then, press corresponding button to
set the exactly delay off time of DA1 or DA2.
Users can set the desired delay off time of DA1 or DA2 through
pressing "
•
Under unlocked status, by pressing "
same kind value, one time only during each setting period.
Take setting Lux value for instant, press "
final value is 60Lux.
•
"
" is only valid for setting value of Lux / Time / STBY / STBY%.
•
"
" is invalid without pressing any values of Lux / Time / STBY /
STBY% first.
Test mode
• By pressing "
by detector's LED flashing for 2sec.
Walking through the detection coverage, both load and
detector's LED turn on 2sec once detector is triggered (Reaction
is regardless of Lux value).
Set load on time in standby mode
Under unlock mode, press "
•
channel for value setting. Then, press corresponding button to
set the desired load on time of DA1 or DA2.
Users can set the desired load on time of DA1 or DA2 through
•
pressing "
Instructions manual |
" under unlock mode to select DA1 for
" under unlock mode to select DA2 for
" is invalid while detector has only one
" button.
" button to enter into Test mode, it is confirmed
" button.
46
Function
" or "
" firstly to select desired
" button to sum the
" + "
" or "
" firstly to select desired
" + "
" , the
www.grupotemper.com