koban KDP-DALI 01 Manual De Instrucciones página 97

Button
Ex-changing auto mode and semi auto mode
•
Under unlocked status, by pressing "
select desired channel for value setting, then press "
auto or semi-auto mode. If press "
selecting one channel, both DA1 and DA2 can select auto or
semi-auto mode simultaneously.
•
The first time pressing the "
2 sec. to indicate detector entering into Auto mode. Press "
button one more time, LED will keep on 2 sec. to indicate
detector entering into Semi-auto mode.
To reset settings on presence detector
By pressing "
settings on presence detector will go back to
potentiometers' settings.
To adjust Lux value
•
Under unlock mode, press "
channel for value setting. Then, press corresponding button to
selected light level threshold is set to presence detector for
switching on the connected load.
•
Users can set the desired Lux value through pressing "
button.
To read-in the actual ambient light level
•
Actual ambient light level can be read-in as threshold for
switching the connected load, if the provided Lux values do not
match user's requirement.
The steps are as below: Press "
LED flashing to enter into learning mode, learning time is 10sec.
Then the actual ambient light level is read-in confirmed by both
load and LED turn on for 5sec to indicate IR-11DALI learning
successfully and then turn off. Afterwards, it returns to Auto
mode.
Note: If the ambient light level is out of the range of 10 -
2000Lux, detector will learn for 10sec, then LED flashes quickly
for 5sec, and the alternative of 10Lux or 2000Lux value will be
stored depending on under 10Lux or above 2000Lux value.
•
" " is only valid for DA1 setting.
www.grupotemper.com
Presence detector for DALi lighting control
Function
" button, LED will flash quickly for
" button aiming to the detector, all
" or "
KDP-DALI 01
" or " " button firstly to
" button directly without
" firstly to select desired
" button till detector's red
Instructions manual |
" to select
"
"
45