Additional Options; Additional Features - Thermador DWHD650G Serie Manual De Uso Y Cuidado

Additional options

Half Load
If you have only a few items to wash (e.g. glasses, cups, plates) you can switch to "Half Load". This will save water, energy
and time. It is recommended to put a little less detergent in the detergent dispenser for half load than you would for a
full load.
Power Wash
This cycle option can be selected to increase wash performance with more water used in extra sequences and at higher
temperatures.
Crystal Protect
This option allows you to wash fragile stemware and dishes by using a shorter cycle time.
Extra Dry
With this option you can raise the tempterature of the rinse water and increase the drying time for improved drying.
Additional features
Sens-a-Wash
An advanced sensor system determines the soil level in the wash water and automatically deletes fresh water ills if they
are not needed, saving energy while ensuring optimal performance.
Sanitized
A dishwasher cycle that has the sanitized symbol
quirements of wash time and water temperature to ensure dishware and kitchenware sanitization.
NOTE: If your household water supply is higher than 120°F, your dishwasher's heating time may be reduced and the "Sani-
tized" LED or symbol may not illuminate. The symbol or LED will automatically display during Auto Wash and during Auto
Wash when the Half Load, Extra Dry or Power Wash options are selected.
Time Remaining Indicator
When the cycle is selected, the remaining running time of the cycle is indicated on the digital display. The running time
is determined during the cycle by the water temperature, the number of utensils as well as the degree of soiling and
may vary (depending on the selected cycle).
PowerBeam ®
An LED illuminates the loor to indicate the unit is running. Do not open the dishwasher door until the LED is no longer
visible on the loor.
NOTE: If the appliance is installed at eye-level, the LED is not visible.
To change setting:
• Open the door.
• Turn unit on by pressing [ON/OFF].
• Hold down [NORMAL] and press and hold [START] until the display indicates "H:00".
• Release both buttons.
The LED for [NORMAL] lashes and display indicates "H:00".
•
• Press [NORMAL] until the display shows "1:01"
• Press [QUICK CLEAN] to switch between "1:01"=ON and "1:00"=OFF and press [START] to save your setting.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
• Open the door.
• Turn unit on by pressing [ON/OFF].
Press [+] until the display shows "h:01" = 1 hour to "h:24" = 24 hours
•
• Press [+] or [–] until the displayed time corresponds with your requirements.
• Press [START]. Delay start is activated.
To cancel delay start:
• Press the [+] or [–] until "h:00" is indicated on the digital display. You can change your cycle selection at any time
before the cycle starts.
• Close the door.
or the "Sanitized" LED lit has been tested to meet very strict re-
16