Registration And Download I Nformation; Maintenance And Service - Amann Girrbach Ceramill map 100 Instrucciones Para La Instalacion Uso Y Manutencion

axIs reFerenCInG wItH
CeramILL maP 100
The rotation and swing axis both have a position
encoder that enables the scanner to read the
actual axis position. This is only possible once
the axes have been placed at least once into the
starting position (referencing). For this reason, it
is necessary to turn the rotation axis completely
around 360 ° and the swing axis at 90 ° before
using the scanner. This referencing must be carried
out before every re-start!
In order to carry out this movement press the
red release button, then turn the model table
around 360 ° and swing the axis to 90 °.
The rotation axis is re-positioned to zero (the
starting position) whilst the swing axis is stillf reely
manoeuvrable. Once the swing axis is in an appro-
ximately 17 ° angle, the rotation axis is locked
and can then only be opened by pressing the red
release button!
maIntenanCe anD
serVICe
The scanner must be cleaned regularly. Switch-off
scanner and vacuum-clean the inner part of the
scanner carefully. Please do NOT clean the optics
of the 3D sensor (upper part in scanner) - this
may cause damage.
Q u I C K G u I D e I n s ta L L at I o n
DIsturBanCes anD
rePaIr
Please note: The scanner is a sensitive optical
device. It is therefore only to be serviced by
trained technical staff. With faults which cannot
be cleared by re-starting the scanner and the
software, please contact the M-Center helpdesk
number.
Germany: +49 7231 957 100
Austria : +43 5523 62333 390
International: +43 5523 62333 399
helpdesk@amanngirrbach.com
On weekdays from 08:00 am to 05:00 pm
reGIstratIon anD
DownLoaD I nFormatIon
QuICK reGIstratIon m-Center
1. Registration under www.ceramill-m-center.com.
2. On this page, click on "registration".
3. Then fill in the form fields with your personal
data and enter all serial numbers.
GB
15