Yeedi K652G Manual De Instrucciones página 25

4. Troubleshooting/4.2 Wi-Fi Connection
Before Wi-Fi setup, make sure Robot, mobile phone, and Wi-Fi network meet the following requirements�
Robot and Mobile Phone Requirements
• Robot is fully charged and the power switch of Robot is turned on�
• Wi-Fi status light slowly flashes�
• Turn off mobile phone's cellular data (you can turn it back on after setup)�
Wi-Fi Network Requirements
• You are using a 2�4GHz or 2�4/5 GHz mixed network�
• Your router supports 802�11b/g/n and IPv4 protocol�
• Do not use a VPN (Virtual Private Network) or Proxy Server�
• Do not use a hidden network�
• WPA and WPA2 using TKIP, PSK, AES/CCMP encryption�
• WEP EAP (Enterprise Authentication Protocol) is not supported�
• Use Wi-Fi channels 1-11 in North America and channels 1-13 outside North America (refer to local regulatory agency)�
• If you are using a network extender/repeater, the network name (SSID) and password are the same as your primary network�
25
EN