Chicco HUMI FRESH Manual De Instrucciones página 32

basin. Use a sponge to remove any limescale
residues in the basin. Rinse the basin (8) at
approximately 300 ml of cold drinking tap
7. Use a soft and clean cloth to dry carefully
the internal part of the tank (6) and the in-
ternal part of the basin (8). Use a soft and
movable essence holder (1), the removable
(14) and its magnetic ring.
level sensor (14) and reassemble the level
sensor on the tank (6) rotating it carefully
WARNING!
netic ring has been inserted correctly into the
9. insert the removable essence holder (4)
into the lid (1) making sure that it is mount-
ed to the special supports provided (3) as
10. Clean the outer surfaces of the device
not use abrasive products, detergents,
alcohol, solvents or similar products as
they may cause permanent damages to
the surfaces.
11. In order to use the device again, repeat
the procedure from step 5 to step 8
OPERATIONS and repeat the procedure
ING THE DEVICE ON.
12. WARNING! If you intend not to use the
humidifier after having cleaned it, store
the device and all its components in a
clean and dry place, protected against
dust, direct sun light and heat sources,
WEEKLY CLEANING
During normal use of the device, the salts
mation of scale residue in the basin (8), on
PRELIMINARY
STANDBY / TURN-
level sensor (14), on the magnetic ring, and in
the area, and in particular it depends on the
- faster is the formation of salt deposits.
performance until blocking it, increasing its
noise and compromising the normal oper-
ation. Besides daily cleaning of the entire
cleaning of the tank every three days, in
order to preserve the optimum conditions,
-
DAILY CLEANING.
vinegar.
and shake the tank for approximately 10
seconds.
place for at least 4 hours (even better if
overnight).
as explained in paragraph DAILY CLEAN-
ING.
sponge.
8. Clean and dry accurately the internal part
cloth.
above until all limescale residues are com-
pletely removed.
-
level sensor (14) and reassemble the level
32
-
-