Troubleshooting - Mi-T-M CWC Serie Manual Del Operador

SYMPTOM
Engine will not start.
No discharge at nozzle when
trigger mechanism is squeezed.
Low or fluctuating pressure.
Water is leaking from the "Thermal
Relief Valve."
Oil appears milky or foamy.
Oil leaking from unit.
Detergent will not siphon into
Low Pressure Detergent mode.
(Optional Feature.)
Water flows back into detergent
container.
Water flows from the nozzle when the
trigger gun is locked in the off
position.
Water is leaking at safety relief.
8

troublesHootinG

PROBABLE CAUSE
Various engine problems.
Unit components are frozen.
Inadequate water supply.
Kink in water inlet hose.
Kink in high pressure discharge hose.
Water inlet screen obstructed.
Pump sucking air (prime eliminated).
Not in high pressure mode.
Obstructed or worn spray nozzle.
Damaged or obstructed valve assy.
on pump.
Pump packings worn.
Bypass valve not operating correctly.
Water temperature is too high.
Defective valve.
Water in oil.
DO NOT USE!!!!!
Detergent strainer is not completely
submerged in detergent solution.
Detergent strainer obstructed.
Detergent hose cut, obstructed or
kinked.
Detergent adjusting knob turned to
closed position.
Detergent nozzle not being used.
Nozzle assembly is plugged.
Too many high pressure hose
extensions attached to the water outlet.
Ball & Spring in Venturi stuck.
Ball & Spring in Venturi reversed,
missing or corroded.
Gun is malfunctioning.
Safety Relief/ Burst disk is ruptured
caused by an unloader malfunction.
REMEDY
Refer to the Engine Manual
accompanying your unit.
Allow to thaw. If any part of the unit
becomes frozen, excessive
pressure may build up in the unit
which could cause the unit to burst
resulting in possible serious injury to
the operator or bystanders.
Ensure hose is 3/4" diameter and
incoming water supply is turned on.
Remove kink.
Replace kinked high pressure hose.
Remove screen, clean or replace.
Tighten all water intake connections.
Eliminate leaks in intake line.
Re-prime.
Insert high pressure nozzle.
Remove, clean or replace.
Remove, inspect, clean or replace.
Replace packings.
Repair or replace.
Do not allow unit to operate in
the bypass mode (with trigger gun
closed) for more than three minutes.
Replace.
Change pump oil. Fill to proper
level.
Contact your Customer Service.
Check, submerge if necessary.
Inspect, clean or replace.
Inspect, clean or replace.
Open adjusting knob. Refer to
"Cleaning with Detergents" pg. 5
Insert 6540° (BLACK) nozzle.
Clean or replace.
Use one extension maximum.
Remove, clean or replace.
Remove, clean or replace.
Repair or replace.
. Replace safety Relief/ Burst disk.
NEVER run unit without safety
Relief/ Burst disk. Doing so can
cause an explosion!
2. Detect and correct unloader
problem.
CWC-GASOLINE / DIESEL Operator's Manual