Maintenance - Storti Frasto Tornado 9-11 Manual Empleo Y Mantenimiento

3) To distribute the product in the feeder first actuate the unloading belt lever and then the unloading door ope-
ning lever to the desired amount.
4) When the unloading process is completed, close the door again by moving the lever in the opposite direction.
Wait until the conveyor belt is completely empty and then stop it by using the appropriate lever.
5) At the end of the whole process the tractor and machine must be parked on a firm, preferably flat, surface,
with the handbrake on, the cutter guards lowered and the rear wall and cutter lowered to the ground.
6) Should the tractor be unhitched from the mixer wagon, lower the support foot and lock the machine using the
parking brake or the special wedges.
7) Unhitch the cardan shaft and rest it in its support. Lock the support foot using the cock in case of hydraulic
support foot or using the clamp on the lever in case of mechanical support foot.
Note: Always pull the key out from the tractor's dashboard before leaving the tractor unattended.
Greasing
Replace
Check
Check
Unloading belt and doors
Transmission reduction unit oil.
Bearings
Universal joint cross-journal
Nuts and wheels
Oil leaks

MAINTENANCE

Page After After
the first the first
10 hours
100 hours
Time intervals (in hours)
4 8 50 200 400
104