Gree GUD35T/A-T Manual De Proprietário página 39

3.2.7 Installing the Front Panel
As shown below, take off the 4 corner covers from the front panel and loose the
hexagon screw bolts on the 4 fasteners to the maximum. The position marked with
―PIPING SIDE‖ on the front panel will direct right at the pipe mouth of the indoor
unit.
(1) Temporarily hang the 4 fasteners on the corresponding hooks of the main body
of the indoor unit (Do not let the conducting wires get involved into the sealing
material).
(2) Screw in the hexagon screws beneath the 4 fasteners by about 15mm (front
panel will rise).
(3) As shown below, turn the front panel according to the arrow direction so that the
front panel can be well connected with the ceiling.
(4) Screw up the screws until the thickness of the sealing material between the
front panel and the ceiling is 5-8mm.
Swing flap motor
Notice
(1) Improper screw looseness will lead to the following problem.
②
Piping position
③
④
Ceiling
Indoor unit
Air outlet
DC Inverter U-match Series Cassette Type Unit
①
Latch
⑤
35
Hook
②
Indoor unit
5~8mm(1/4~3/8inch)
Panel