Product Specifications - Enerpac AHP-40 Manual Del Usuario

IMPORTANT: Hydraulic equipment must only be serviced
by a qualified hydraulic technician. For repair service,
contact the Authorized ENERPAC Service Center in your
area. To protect your warranty, use only ENERPAC oil.
AHP 40 Pump Performance
Oil Flow vs. Oil Pressure at
Varying Air Drive Pressures
Oil Pressure – psi [bar] (MPa)
Drive Pressure
Chart 1, AHP 40
Temperature Range:
Viscosity Range:
Hydraulic Oil:
Seal Material:
Usable Reservoir Capacity:
Internal Safety Relief Setting:
Decibels:
Weight:
Minimum Operating Air Pressure:
Maximum Operating Air Pressure:
Air Consumption:
Model Number
Ratio:
Pressure @ 100 psi [6,9 bar] (690 mPa)
Flow (no load)
WARNING: Immediately replace worn or damaged parts
by genuine ENERPAC parts. Standard grade parts will
break causing personal injury and property damage.
ENERPAC parts are designed to fit properly and withstand high
loads.

PRODUCT SPECIFICATIONS

60°–200°F [16°–93°C]
150–165 S.U.S. [15–20c.St]
ISO Grade 32
BUNA-N, Urethane, Teflon
2.0 gal. [7,6 liters]
5300-5500 psi [366-380 bar] (36,5–37,9 MPa)
80 @ 100 psi [6.9 bar] (689 kPa)
45 lbs. [20,5 kg.]
20 psi [1,4 bar] (138 kPa)
125 psi [8,6 bar] (861 kPa)
3 scfm
AHP-40 Series
1:44
4400 psi [300 bar] (30 MPa)
25 cu. in. / min. [41 l/min.]
2
AHP 60 Pump Performance
Oil Flow vs. Oil Pressure at
Varying Air Drive Pressures
Oil Pressure – psi [bar] (MPa)
Drive Pressure
Chart 2, AHP 60
AHP-60 Series
1:64
5000 psi [350 bar] (35 MPa)
17 cu. in. / min. [28 l/min.]