Day 1 - Boundary Awareness; Days 2 Thru 4 - Continue Boundary Awareness - Petsafe HIG11-13655 Manual De Adiestramiento Y Funcionamiento

Day 1 - Boundary Awareness

Phase
1
Perform three training sessions per day, each lasting 10-15 minutes.
Goal:
To have your pet learn that the Boundary Flags and warning beep from
the Receiver Collar defines the new Pet Area.
Setup:
• Program the Static Correction Level on the Receiver Collar to Level 1
Tone Only training mode.
• Put a separate non-metallic collar on your pet's neck ABOVE the
Receiver Collar and attach a leash.
• Have tiny pieces of treats that your pet will
find desirable available (hot dogs or lunch
meat work well).
• Have your pet's favorite play toy available.
Steps:
1. Begin by walking your pet on a leash in the
Pet Area. Calmly praise and talk to your pet.
2. Move toward the Boundary Flags (10A).
Keep your mood happy.
3. With full control of your pet on a leash,
walk to the flags. As your pet enters the Static Correction Zone, the Receiver Collar will
begin to beep (10B). Allow your pet to stay in the Static Correction Zone for up to 2
seconds then gently help him back into the Pet Area (10C). Immediately praise and offer
your pet a treat as he enters the Pet Area, even if you have helped with the leash.
4. Repeat this process at the same Boundary Flag until your pet resists going into the
Static Correction Zone.
5. Aim to master 3-4 Boundary Flags per session. Make this FUN! Praise if your pet quickly
retreats or resists going into the Static Correction Zone.
Days 2 thru 4 -
Phase
2
Continue Boundary Awareness
Perform three training sessions per day, each lasting 10-15 minutes.
Goal:
To train your pet to stay in the Pet Area and respect the boundary.
Setup:
• Program the Static Correction Level on the Receiver Collar to Level 2.
• Put a separate non-metallic collar on your pet's neck ABOVE the Receiver Collar and
attach a leash.
• Have tiny pieces of treats available (hot dogs or lunch meat work well).
• Have your pet's favorite play toy available.
Steps:
1. Repeat steps 1-5 in Phase One.
2. If your pet does not respond to the Static Correction, confirm that the Receiver Collar is
fitting properly according to Step 9 on page 20.
3. If the Receiver Collar is fitted properly and your pet does not respond to the Static
Correction, increase the Static Correction Level by 1. Watch for slight reactions at first such
as ears up, head turned, looking at the ground.
4. Stay at the same flag until your pet resists going into the Static Correction Zone.
Be sure the extra collar does not put pressure on
the Contact Points.
Be sure the extra collar does not put pressure on the Contact Points.
www.petsafe.net
10B
10A
10C
23