Jotul F 305 Serie Instrucciones Para Instalación página 11

4.3 Outside air connection
If external air supply is not used
Fig. 12
2. If external air supply is not used, the external air connector
(A) can be unscrewed, if desired. Remove the four screws
used for fastening the external air connector and then the
connector itself. (For products with base: If necessary,
you can unscrew the heat shield beneath the burn chamber
in order to facilitate the dismantling of the external air
connector.
3. Install the convection plate back in its place after removing
the external air connector.
Outside air connection through bottom
plate in base
Fig. 13
1. Place a cardboard plate on the back of the bottom plate
before knocking out the cover (A) with a hammer in order to
prevent the pieces from damaging something around them.
A
Fig. 14
2. See the installation instructions that follow with the external
air set.
3. Attach the hose to the external air connector with a hose
clip to avoid using joints. The external air hose insulation
ends approx. 100 mm below the burn chamber.
ENGLISH
A
11