Deactivating Or Activating The Easy-Start Feature - Philips Sonicare HealthyWhite 700 Serie Manual Del Usuario

1
2
4
3
Clean and White mode
2 minutes of Clean mode, with an additional 30 seconds of White mode to focus on your
visible front teeth.
Note: When Sonicare is used in clinical studies, the default 2-minute Clean mode must be selected.
However, in whitening/stain reduction studies, the Clean and White mode must be selected. The handle
should be fully charged and the Easy-start feature deactivated.
Features
Easy-start
- This Sonicare model comes with the Easy-start feature activated.
- The Easy-start feature gently increases power over the first 14 brushings to ease into the
Sonicare experience.
Note: Each of the first 14 brushings must be at least 1 minute in length to move through the Easy-start
ramp-up cycle properly.
Note: When the Clean and White mode is selected, the Easy-start feature is inactive.

deactivating or activating the Easy-start feature

1 Attach your brush head to the handle.
2 Place the handle in the plugged-in charger.
- To deactivate Easy-start:
Press and hold the power on/off button for 2 seconds. You hear 1 beep to indicate that the Easy-
start feature has been deactivated.
- To activate Easy-start:
Press and hold the power on/off button for 2 seconds. You hear 2 beeps to indicate that the Easy-
start feature has been activated.
Note: Using the Easy-start feature beyond the initial ramp-up period is not recommended and reduces
Sonicare's effectiveness in removing plaque.
smartimer
The Smartimer indicates that your brushing cycle is complete by automatically turning off the
toothbrush at the end of the brushing cycle.
Dental professionals recommend brushing no less than 2 minutes twice a day.
If you want to pause or stop brushing during your 2-minute cycle, press and hold the power on/off
button for 2 seconds. Press the power on/off button again and the Smartimer picks up where you
left off.
The Smartimer automatically resets to the beginning of a 2-minute cycle if:
- brushing is paused for 30 seconds or longer.
- the handle is returned to the charger.
Quadpacer (select models)
- The Quadpacer is an interval timer that has a short beep and pause to remind you to brush
the 4 sections of your mouth evenly and thoroughly.
- When you use the two-minute Clean or Sensitive mode, you hear a short beep and a pause
in brushing action at 30, 60 and 90 second intervals.
- When you use the Clean and White mode, you hear and feel a change in the brush head
sound and motion after 2 minutes of Clean mode. Then move the brush head to the visible
top front teeth and brush them for 15 seconds. At the final beep and pause, move to the
visible bottom teeth and brush them for 15 seconds.
EnglisH
7