Performance 84242387 Manual De Instrucciones página 17

Note: The Exhaust Muffler is removed for illustration purposes only. It is not necessary to remove the Exhaust Muffler to remove
the Stabilizer Shaft.
6. Rear Stabilizer Shaft Insulator Clamp Bolt (1) » Remove [4x]
7. Rear Stabilizer Shaft (2) » Remove
Installation Procedure
Caution: Use care when removing or installing the stabilizer shaft as coating can be removed by contact with tools or other
vehicle components. Corrosion will occur and early stabilizer shaft failure will be the result.
1. Prior to installation verify that the ID label (1) is on the right hand side of the vehicle.
2. Install the stabilizer shaft with the vehicle at curb height using jack stands.
3. Rear Stabilizer Shaft (2) » Install
Camaro Suspension Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
Bar Routing May Vary
IR 23SE16
PART NO.
DATE
23SE16 Initial Release - Andrew Rogers
84242387
SHEET
REVISION
17 54
OF
AUTH
2546929