Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Caution: Refer to Fastener Caution.
4. Insert stabilizer shaft link and loosely install nut
5. Rear Stabilizer Shaft Insulator Clamp Bolt (1) » Install and tighten [4x] 58 N·m (43 lb ft)
6. Install the wiring harness to the top left stabilizer shaft insulator clamp bolt.
7. Install the two rear exhaust muffler isolators.
Note: Tighten at curb height using jackstands.
Note: DO NOT allow the upper stabilizer shaft ball stud to rotate.
8. Using the proper size allenwrench, hold the upper stabilizer shaft ball stud.
9. Upper stabilizer shaft link nut» Tighten 43 N·m (32 lb ft)
10. Install Tire and Wheel Assembly and lower vehicle
Camaro Suspension Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
84242387
IR 23SE16
PART NO.
DATE
23SE16
Initial Release - Andrew Rogers
18
SHEET
REVISION
54
OF
AUTH
2546929
Publicidad
Tabla de contenido
