Performance 84242387 Manual De Instrucciones página 3

Caution: Perform the following steps before beginning any vehicle lifting or jacking procedure:
• Remove or secure all of the vehicle contents in order to avoid any shifting or any movement that may occur during the vehicle
lifting or jacking procedure.
• The lifting equipment or the jacking equipment weight rating must meet or exceed the weight of the vehicle and any vehicle
contents.
• The lifting equipment or the jacking equipment must meet the operational standards of the lifting equipment or jacking
equipment manufacturer.
• Perform the vehicle lifting or jacking procedure on a clean, hard, dry, level surface.
• Perform the vehicle lifting or jacking procedure only at the identified lift points. DO NOT allow the lifting equipment or jacking
equipment to contact any other vehicle components.
Failure to perform the previous steps could result in damage to the lifting equipment or the jacking equipment, the vehicle, and/
or the vehicle contents.
Vehicle Lifting– Frame Contact Lift
Note: The vehicle should be lifted so that the hoist pads and or lift arms do not contact the rocker panel molding. The hoist pad
must be located in the designated area. In the front location, place the lift pads on the rocker outer panel weld flange. In the
rear location, place the lift pads on the rocker outer panel rear cradle brace. Care should be taken to ensure the hoist pad is
inside the rocker panel molding cut out area (notch) to prevent damage to the vehicle.
Front Lift Pads
When lifting the vehicle with a frame-contact lift, place the front lift pads on the rocker outer panel weld flange (1), as shown
Rear Lift Pads
When lifting the vehicle with a frame-contact lift, place the rear lift pads on the rocker outer panel weld flange (2), as shown.
Vehicle Jacking
Caution: When you are jacking the vehicle at the front locations, be certain that the jack or the jack lift pad does not contact
the front fascia, front fascia air dam, or the front fenders. If such contact occurs, vehicle damage may result. When jacking at
selected front locations additional clearance may be required for the jacking points.
Note: When you are lifting a vehicle with a service jack, block the wheels at the opposite end from which you are lifting. Use
jack stands to provide additional support.
Front of Vehicle
When using a service jack under the front of the vehicle use one of the following locations:
Place the service jack pad in the same location as shown for the front lift pads or on the front center jack pad.
Rear of Vehicle
Note: Place jackstands ONLY under strong and stable vehicle structures.
Place the service jack pad in the same location as shown for the rear lift pads.
Camaro Suspension Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
84242387
IR 23SE16
PART NO.
DATE
23SE16 Initial Release - Andrew Rogers
3
SHEET
REVISION
54
OF
AUTH
2546929