Important Safety Instructions; Tools And Parts Needed; Parts Included - Siemens LC479050UC Manual De Instalación

Important Safety Instructions

Tools and Parts Needed

Parts Included

WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
TO PERSONS, OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer. If you have
questions, contact the manufacturer.
b) Before servicing or cleaning the unit, switch power off at service panel and
lock service panel. This will prevent power from being switched on acciden-
tally. When the service panel cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
c) Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes & standards, including fire-rated con-
struction.
d) Sufficient make-up air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to prevent back-
drafting. Follow the heating equipment manufacturer's guideline and safety
standards such as those published by the National Fire Protection Associa-
tion (NFPA), the American Society for Heating, Refrigeration and Air Condi-
tioning Engineers (ASHRAE), and the local code authorities.
e) Due to the size and weight of this unit, two installers are recommended.
f) When cutting or drilling into wall or ceiling, do not damage electrical wiring or
other hidden utilities.
g) To properly exhaust air, be sure to duct air outside. Do not vent exhaust air
into spaces within walls, ceilings, attics, crawl spaces, or garages.
h) Install this hood in accordance with all requirements specified.
i) The hood is equipped with an internal blower. Other ventilator blowers CAN-
NOT be substituted.
WARNING - TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCT-
WORK.
WARNING: Turn off power circuit at service panel and lock out panel before wir-
ing this appliance.
CAUTION: This unit is approved for use with residential appliances. For general
residential kitchen ventilating use only. DO NOT use to exhaust hazardous or
explosive materials or vapors. Vent unit to the outside.
Note: The appliance referred to throughout this manual is manufactured by BSH
Home Appliances Corporation.
1) Metal Duct Cover (optional)
2) Transition (some installations; style varies)
3) Ductwork as necessary (style varies)
4) Duct Tape
5) Phillips Head Screwdriver
6) Drill with 1/4" bit
7) Tape Measure
1) Chimney sections (2)
2) Filters (3)
3) Hood
4) Screws, 5x60 (6)
5) Sheet Metal Screws, 3.9 (2)
6) E8 plugs (6)
7) Positioning Templates (2)
English 1