Moen Press & Mark Guia De Instalacion página 3

2. DRILL & MOUNT
Hollow Wall, proceed to Step
For
For Wood Stud, proceed to Step
Hollow Wall Option
2 2
a.1 a.2
C
5/16" bit
x2
A
Drill 5/16" holes on the Ink Prepare the Drywall Anchors (A) by
Stamp marks. pushing on the center and bringing
the two tabs together.
3
3. SNAP TO WALL
2
a.1
2
b.1
2
a.3
x2
Insert a Drywall Anchor (A) into
each hole. Ensure the tabs
are oriented horizontally as
shown above.
2. DRILL & MOUNT
Hollow Wall Option
2
a.4
A
x2
1. Lightly tap Drywall Anchors 2. Engage the Drywall Anchors (A)
(A)
with a hammer until flush. with the Red Pin (F). Tap the Pin
lightly with hammer until the
lower portion of the Pin engages
the Anchor. The upper portion
of the Pin will remain exposed.
Remove Pin once engaged.
Hollow Wall Option
2
a.5
A
x2
B
x2
1. With arrow facing up, align 2. Insert Wood Screws (B) through
Mounting Bracket (D) over Mounting Bracket (D) and tighten
Anchors (A). with a screwdriver, ensuring
Bracket remains level.
Video Installation Guide: www.moen.com/pminstall
3. SNAP TO WALL
F
D
4