Moen Press & Mark Guia De Instalacion página 4

2. DRILL & MOUNT 2. DRILL & MOUNT
Wood Stud Option
2
b.1
1/16" bit
Drill 1/16" holes on the Ink
Stamp marks.
Wood Stud Option
2
b.2
B
x2
1. With arrow facing up, align Mounting Bracket (D)
over holes.
2. Insert Wood Screws (B) through Mounting Bracket
(D) and tighten with a screwdriver, ensuring
Bracket remains level.
5
3. SNAP TO WALL 3. SNAP TO WALL
3
a
DO NOT LOOSEN SET SCREW
Remove Ink Stamp (C) by 'gently' pulling it out of the
Post (E). You DO NOT need to loosen the Set Screw (H)
to remove the Ink Stamp.
3
b
D
Attach the Post (E) onto the Mounting Bracket (D).
Push Post downward and toward wall. Secure to wall
with a snap! Do not tighten Set Screw, it is factory-
installed for optimal performance.
Video Installation Guide: www.moen.com/pminstall
D
E
Installation complete!
3. SNAP TO WALL 3. SNAP TO WALL
C
To remove post: use Hex Wrench (G) to loosen
Set Screw (H).
6