Seca 727 Manual De Instrucciones Y Garantía página 75

Fault
... the display "bAtt"
appears?
... the display "StOP"
appears?
... the display "tEMP"
appears?
... after switching on,
measured results are
transmitted for the first
time and two acoustic
signals are heard?
... only the item "SYS" is
visible in the "rF" menu?
... only the "SYS" and
"Lrn" items are visible in
the "rF" menu?
... the "APrt" and "tiME"
menu items are not visi-
ble in the "rF" menu?
... when the menu is
called up, the item "rF" is
not displayed?
Cause/Remedy
Battery block discharged.
- Charge battery block.
The maximum load has been exceeded.
- Remove load.
The ambient temperature of the scale is too high
or too low.
- Set up scale in an ambient temperature
between +10 °C and +40 °C.
- Wait approx. 15 minutes until scale has
adjusted to ambient temperature.
The device was unable to send measured results
to the wireless receiver (seca wireless printer or
PC with seca USB wireless adapter).
– Check that the scale is integrated in the
wireless network.
– Check that the receiver is switched on.
Nearby HF equipment (e.g. mobile phones) are
interfering with reception.
- Make sure that HF equipment is kept at least
1 metre away from transmitters and receivers
in the seca wireless network.
NOTE
If such interference is not eliminated, no fur-
ther acoustic warnings are given with sub-
sequent attempts at transmission.
The wireless module is disabled.
- Activate wireless module ("Activating the wire-
less module (SYS)" on page 68).
The wireless module is activated but no wireless
group is set up.
- Set up wireless group ("Setting up a wireless
group (Lrn)" on page 69).
No wireless printer is registered to the wireless
group.
- Use the "Lrn" menu item to log the wireless
printer into the wireless group ("Setting up a
wireless group (Lrn)" on page 69).
The wireless module of the scale is defective.
- Please notify maintenance service.
English
What do I do if ...? • 75