Inserting And Connecting The Battery Block; Connecting The Power Pack And Charging The Battery Block - Seca 727 Manual De Instrucciones Y Garantía

Inserting and
connecting the battery
Connecting the power
pack and charging the
battery block
58 •
for the power pack are located on the underside of the
scale.
1. Push the battery compartment latch in the direction
of the printed word "Battery" and flip open the lid.
block
2. Remove the connecting cable from the battery
compartment.
3. Connect the plug contacts of the connecting cable
to the battery block supplied.
4. Insert the battery block in the battery compartment.
5. Close the battery compartment.
WARNING!
Personal injury and damage to device due to use
of incorrect power packs
The voltage supplied by standard power packs
may be higher than their indicated rating. This
may cause the scale to overheat, catch fire,
melt or short-circuit.
– Only use genuine seca plug-in power packs
1. Insert the power plug necessary for your power
supply in the power pack.
2. Insert the device connector of the power pack in
the connecting socket in the base of the scale.
3. Plug the power supply unit into a power supply
socket.
4. Leave the scale connected to the power supply for
at least 24 hours when charging for the first time in
order to charge the battery block fully.
with a controlled 12 V output voltage.