Canceling A Cycte; Changing A Cycle Or Setting - Kenmore ULTRA WASH 665.15762 Manual De Uso Y Cuidado

Use this cycle for leads Use bcd_h
with normal ar'nounts of detergent
food soil. (The energy- dispenser
usage label is based on sections.
this cycle.)
Soil Wash Rinse Main Rinse Final Dry Time Water
Level Wash or Heated {rain} Usage
S_'18ed Purse Rinse (gellL)
• • II • • • so* io.w
4o.g
Heavy 140_F 140_F
(s0oc) (emo)
• • • • • _* _st_2.7
Medium t40_F 140_F
(s0oc) (emo)
• • • • • 7t* 6._4._
Ligl_t 140_F
{emc)
Use this cycle for pre- Use
rinsed and lightly-soiled covered
loads. This cycle uses detergent
less hot water than the dispenser
Normal Wash cycle, section.
Soil Wash Rinse Main Rinse Final Dry Time Water
Level Wash or Heated {rain} Usage
S_'18ed Purse Rinse (gellL)
• • • • • 7s* _2.7
Heavy .14_}_F 14S_F
• • • • s_ 4._117.4
Ligl_t 140_F
{emc)
Use this cycle for china Use
and crystal. This cycle covered
uses a light wash and detergent
gentle dry. During the dispenser
heated dry, the heating section.
element cycles on and off.
Soil Wash Rinse Main Rinse Final Dry T#_e Water
Level Wash or Heated (rain} Usage
S_'_8ed Purse Rinse (gellL)
• • • • • 72* _2.7
Heavy 130_F cycled
• • • • ._* 4._17.4
Lig I_t 130_F cyeled
Use this rinse cycle for DO not use
rinsing dishes, glasses, detergent
and silverware that will with this
not be washed right away. cycle.
Soil Wash Rinse Main Rinse Final Dry Time Water
Level Wash Heated (rain} Usage
Sensed Rinse (galiL}
• • t€ _.2/1&4
Heavy
g 10 2.2/8.2
Light
NOTE: The sensor in your dishwasher monitors the soil level.
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance.
Canceling a Cycle
Anytime during a cycle, press
CANCEWDRAIN glows. The dishwasher pauses for about 5
seconds and starts a 2-minute drain (if needed). Let the
dishwasher drain completely. The light goes Off when the
dishwasher finishes the drain.
To stop the drain
You can press CanceVDrein again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
NOTE: A small amount of water remains in the dishwasher. This
is normal.
To clear the indicators
Press CanceVDrain before starting the dishwasher to clear all
options and cycles.
Changing a Cycle or Setting
During the first minute of a cycle
Press a new cycle and/or options.
After the first minute of a cycle
1. Press
CANCEWDRAIN glows. The dishwasher pauses for 5
seconds and starts a 2-minute drain (if needed). Let the
dishwasher drain completely.
2. Check the detergent dispensere. If the main wesh cup hes
opened and the detergent washed away, refill the cups as
needed.
& Close the door.
4. Press a new cycle and/or options.
5. Press START.
13