Canceling A Cycle; Changing A Cycle After Dishwasher Is Started; Adding A Dish After Dishwasher Is Started; Dishwasher Efficiency Tips - Kenmore 665.1389 Serie Manual De Uso Y Cuidado

Tabla de contenido

Idiomas disponibles

Control Lock Option

Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCK ON is lit, all buttons are

disabled. The dishwasher door can still be opened/closed while the controls are locked.

To turn on the Lock

Press and hold HEATED DRY for 4 seconds. LOCK ON will light up. If you press any pad while your dishwasher is locked, the light

flashes 3 times.

NOTE: The dishwasher cannot run if the control is locked.

To turn off the Lock

Press and hold HEATED DRY for 4 seconds. The light turns off.

1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.

2. Press CANCEL/DRAIN button once. The Cancel/Drain light will light up.

3. Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let

the dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.

You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.

1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.

2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser

before restarting your new cycle.

3. Press CANCEL/DRAIN twice to reset the control.

4. Select new cycles and options.

5. Press START/RESUME and firmly close the door within 3 seconds.

NOTE: If the door is not closed within 3 seconds of pressing START/RESUME, press START/RESUME again.

1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.

2. Check whether the detergent dispenser cover is still closed. If it is open, the wash cycle has already started and

adding a dish is not recommended.

3. If detergent has not yet been used (detergent dispenser cover is closed), you may add a dish.

4. Press START/RESUME and firmly close the door within 3 seconds.

Hot water dissolves and activates the dishwasher detergent. Hot water also dissolves grease on dishes and helps glasses dry spot-free.

For best dishwashing results, water should be 120°F (49°C) as it enters the dishwasher. Loads may not wash as well if the water

temperature is too low.

Additional efficiency tips

To save water, energy and time, only scrape dishes. Do not rinse dishes before putting them into the dishwasher.

Use a delay feature to run your dishwasher during off-peak hours. Local utility providers recommend avoiding heavy

usage of energy at certain times of day.

During the summer, run your dishwasher at night. This reduces daytime heat buildup in the kitchen.

Use a rinse aid to improve drying.

All manuals and user guides at all-guides.com