Eaton 8kW Manual Del Propietário página 29

4.12.2 RETURN TO SERVICE
To return the unit to service after storage, proceed as follows:
1. Verify that utility power is turned off and that the AUTO/OFF/
MANUAL switch is set to OFF.
2. Check the tag on the engine for oil viscosity and classification.
Verify that the correct recommended oil is used in the engine
(see the Engine Oil Recommendations section). If necessary,
drain and refill with the proper oil.
3. Check the state of the battery. Fill all cells of unsealed bat-
teries to the proper level with distilled water. DO NOT USE
TAP WATER IN THE BATTERY. Recharge the battery to 100
percent state of charge, or, if defective, replace the battery.
See "Specifications," for type and size.
4. Clean and wipe the entire generator.
5. Make sure the 7.5A fuse is removed from the generator con-
trol panel. Reconnect the battery. Observe battery polarity.
Damage may occur if the battery is connected incorrectly.
6. Open the fuel shutoff valve.
7. Insert the 7.5A fuse into the generator control panel. Start the
unit by moving the AUTO/OFF/MANUAL switch to MANUAL.
Allow the unit to warm up thoroughly.
8. Stop the unit by setting the AUTO/OFF/MANUAL switch to OFF.
9. Turn on the utility power to the transfer switch.
10. Set the AUTO/OFF/MANUAL switch to AUTO.
11. The generator is now ready for service.
If the battery was dead or disconnected, the exercise timer, cur-
rent date and time must be reset.
NOTE:
4.12.3 MAINTENANCE / ACCESSORY ITEMS
The manufacturer provides all the proper OEM maintenance parts
needed to properly maintain and service your generator along with
accessory type items that provide enhanced performance. We
encourage you to visit us at www.generac.com to locate a local
authorized service provider that can provide you with these itmes,
or you may choose to order directly off the Generator Accessory
Tab on our site.
Not all items listed are available for sale at www.generac.com.
Scheduled Maintenance Kits with Oil
Part Number Description
0J576400SM Kit for 8kW Generator
0J57640SSM Kit for 8kW Generator
0J576600SM Kit for 10kW Generator
0J57660SSM Kit for 10kW Generator
0J576700SM Kit for 13-17KW Generator
0J57570SSM Kit for 13-17KW Generator
0J576800SM Kit for 18-20kW Generator
0J57680SSM Kit for 18-20kW Generator
Cold Weather Kits
0J580000CW Cold Weather Kit 8-20kW
Touch-up Paint
0J579600TP Kit Paint Bisque
Fascia Skirt Wrap
0J580300BF Kit Base Fascia Bisque
Starting Battery
0H3421S Group 26R 12 Volt Battery
** Remote Monitor System
** Auxiliary Transfer Switch Lockout
** GenPad
** Contact your nearest authorized service provider for assistance.
Maintenance
NOTE:
Oil Type
10W-30
5W-30 synthetic
10W-30
5W-30 synthetic
10W-30
5W-30 synthetic
10W-30
5W-30 synthetic
27