Specifications - Eaton 8kW Manual Del Propietário

General Information
1.6

SPECIFICATIONS

1.6.1 GENERATOR
Model
Rated Voltage
Rated Maximum Load Current (Amps) at
240 Volts (LP)*
Main Circuit Breaker
Phase
Number of Rotor Poles
Rated AC Frequency
Battery Requirement
Weight (unit only in lbs.)
Enclosure
Normal Operating Range
These generators are rated in accordance with UL2200, Safety Standard for Stationary Engine Generator Assemblies; and CSA-C22.2 No. 100-04 Standard for Motors and Generators.
* Natural Gas ratings will depend on specific fuel Btu content. Typical derates are between 10-20% off the LP gas rating.
** Circuits to be moved must be protected by same size breaker. For example, a 15 amp circuit in the main panel must be a 15 amp circuit in the transfer switch.
1.6.2 ENGINE
Model
Type of Engine
Number of Cylinders
Rated Horsepower @ 3,600 rpm*
Displacement
Cylinder Block
Valve Arrangement
Ignition System
Recommended Spark Plug
Spark Plug Gap
Compression Ratio
Starter
Oil Capacity Including Filter
Recommended Oil Filter
Recommended Air Filter
Operating RPM
* Engine power is subject to and limited by such factors as fuel Btu content, ambient temperature and altitude. Engine power decreases about 3.5 percent for each 1,000 feet above sea level; and
also will decrease about 1 percent for each 6 C (10 F) above 16 C (60 F) ambient temperature.
6
8kW
33.3
35 Amp
340
Steel
This unit is tested in accordance to UL 2200 standards with an operating temperature of 20 °F (-29 °C) to 122 °F. (50 °C). For areas where tempera-
tures fall below 32 °F (0 °C), a cold weather kit is highly recommended. When operated above 77º F (25º C) there may be a decrease in engine power.
(Please reference the engine specifications section).
8 kW
GH-410
1
14.8
410cc
Part No. 0E7585
0.76 mm (0.030 inch)
8.6:1
Approx. 1.5 Qts
Part # 0G3332
10kW 14kW
240
41.6 58.3
45 Amp 60 Amp
1
2
60 Hz
Part No. 0H3421S, Group 26R, 12 Volts and 525 CCA Minimum
387 439
Steel Steel
10 kW
GT-530
2
18
530cc
Aluminum w/Cast Iron Sleeve
Overhead Valves
Solid-state w/Magneto
Part No. 0E9368
0.76 mm (0.030 inch)
9.5:1
12 VDC
Approx. 1.7 Qts
Part # 070185F
Part # 0E9581
3,600
17kW
70.8
65 Amp
455/421
Steel/Aluminum
14/17 kW
GT-990
2
32
992cc
Part No. 0E7585A
1.02 mm (0.040 inch) 0.76 mm (0.030 inch)
9.5:1
Approx. 1.9 Qts
Part # 0C8127
20kW
83.3
100 Amp
450
Aluminum
20 kW
GT-999
2
36
999cc
Part No. 0G0767A
9.5:1
Approx. 1.9 Qts
Part # 0G5894