Items Supplied; Replacement Blades - Evolution S355 MCS Instrucciones Originales

www.evolutionpowertools.com
15. Disconnect tools before servicing; when
changing accessories, such as blades, bits, cutters,
and the like.
16. Reduce the risk of unintentional stating.
Make sure switch is in off position before plugging
in.
17. Use recommended accessories. Consult the
owner's manual for recommended accessories.
The use of improper accessories may cause risk of
injury to persons.
18. Never stand on the tool serious injury could
occur if the tool is tipped or if the cutting tool is
unintentionally contacted.
19. Check damaged parts. Before further use
of the tool, a guard or other part that is damaged
should be carefully checked to determine that it
will operate properly and perform its intended
function - check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting, and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
20. Direction of feed. Feed work into a blade
or cutter against the direction of rotation of the
blade or cutter only.
21. Never leave tool running unattended. Turn
power off. Don't leave the tool until it comes to a
complete stop.
GETTING STARTED UNPACKING
Caution: This packaging contains sharp objects.
Take care when unpacking. Remove the machine,
together with the accessories supplied from the
packaging. Check carefully to ensure that the
machine is in good condition and account for all
the accessories listed in this manual. Also make
sure that all the accessories are complete. If any
parts are found to be missing, the machine and its
accessories should be returned together in their
original packaging to the retailer.
Do not throw the packaging away;
keep it safe throughout the guarantee period.
Dispose of the packaging in an environmentally
responsible manner. Recycle if possible.
Do not let children play with empty plastic bags
due to the risk of suffocation.
SERIAL NO. / BATCH CODE
The serial number can be found on the motor
housing of the machine.
For instructions on how to identify the batch
code, please contact the Evolution Power Tools
helpline or go to:
www.evolutionpowertools.com

ITEMS SUPPLIED

Description
Instruction Manual
14" (355mm) Mild Steel TCT Blade
Double ended hex key
5mm/8mm (Blade Change)
V-Block
Cutting head assembly
Base/table assembly
Rail bracket and fixings
Thumb screws
Top clamp
Clamp cross bar
Front clamp

REPLACEMENT BLADES

Description
(UK/EU) RAGEBLADE-
14" (355mm)
Multi-Material Cutting
(USA) RAGE355BLADE
TCT Blade
(UK/EU) RAGEBLADE-
14" (355mm)
Diamond Blade
(USA) 14BLADEDM
(UK/EU) M355TCT-66CS
14" (355mm) Mild Steel
Cutting Blade
(UK/EU) S366TCT-90CS
14" (355mm) Stainless
Steel Cutting Blade
14" (355mm) Thin Steel (UK/EU) T355TCT-90CS
Cutting Blade
14" (355mm)
(UK/EU) A355TCT-80CS
Aluminium/ Aluminum
Cutting Blade
14" (355mm) Wood
(USA) GW355TCT-60
Cutting Blade*
*Complies with EN 847-1
11
Quantity
1
1
1
3
1
1
1
3
1
1
2
Part No
355MULTI
355DIAMOND
(USA) 14BLADEST
(USA) 14BLADESS
(USA) 14BLADETS
(USA) 14BLADEAL
EN