Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LED LIGHT (Fig. 10)
Yourdrilltdriver has an LED lightthat
illuminates the driltldrive area ior hands-free
lighlng in any application.,
ON-TOOL BIT STORAGE (Fig, 10a)
Your drillingI drivingcomes with
2 double ended screwdriverblls that store
on each side of the base_
Ftg.10
and 1Oa
L
I
24 PIECE
BIT ACCESSORY
SET (with
! t8t0
and 11834)
Your dritl comes with a 24 piece bit set thai is fitted into the carry I storage case Tl_is bil sol
allows you to pedorm many power drilting I driving jobs
INSTALLING
ACCESSORY
BITS (Flgs.11
and 11a)
t Lock the trigger switch Off by placlng the Forward/Reverse
Selector Switch with Power
Lock-Off in the Center position.
2. Open or close the chuck jaws to a point where the opening is slightly larger than lhe bit size you
intend to use .Atso. raise the trent of lhe driil slightly to keep the bff from falling out e! the chuck
jaws (see Fig. tl).
3 inserl the accessory
bit
4 Relate the chuck clockwise to tighten.. The chuck has an tcon of a hand next to the
word GRIP, pointing to the dtreclion
lo grip, or tighten, the chuck jaws securely on lhe bit
Fig. 11
OPEN JAWS
Flg_ 11 a
'_
(Insert bit)
WARNING:
Make sure to insert the accessory
bit straight Into the chuck
Jaws. Do not Insert the accessory
bit into the chuck Jaws at an angle then tighten,
as shown in Flgurs 11a. This could cause the bit to be thrown from the drill,
resulting
in posstble serious
personal in.fury or damage
to the chuck.
NOTE: Rotate the chu_k body in the direction
of the hand pointing next to word GRIP to
tighten the chuck jews° DO NOT use e wrench to tfghten or loosen the chuck jaws.
2O
1
Publicidad
Tabla de contenido
