Troubleshooting - Hergom ECK Instrucciones Para Instalación, Uso Y Mantenimiento

What to do if... ?
Problem
1. Soot covers the ceramic glass too
quickly
2. The fireplace does not feature a
regular draft
3. Combustion in the fireplace is not
correct
4. The fireplace releases strong
smells or fumes
5. Release of fumes when adding
fuel and during heating
If these indications are not enough to solve the problems,
contact your authorized reseller or chimneysweep service.

TROUBLESHOOTING

Cause
Not enough draft
Wrong adjustment
Excessive quantity of Wet firewood tion; you can also use compressed
Inappropriate fuel
Not enough draft in the fireplace
The stove is full of soot inside
Atmospheric conditions influx
Incorrect lighting
Heating phase
Not enough draft of the fireplace,
the connection of the tube for the
outlet of fumes is not sealed
33
Solution
General observations:
From time to time (according to the
frequency of use) it is necessary to
clean the ceramic glass with a specific
detergent for fireplaces
Refer to the chimneysweep service (it
may be necessary to extend the flue
or modify the lining of the chimney)
Adjust air intakes as indicated in
these instructions (if secondary air
inlet is closed, soot accumulates faster
on the glass, while with a correct
adjustment it could clean by itself)
Refer to the "fuel maximum quality"
section
Refer to the "clean combustion" sec-
wood logs (they are usually uniformly
dry)
Or: with the use of lignite blocks
the glass gets dirty faster than with
firewood
Refer to the "Short information on
materials and ways of combustion"
section.
Refer to the "Maintenance and clean-
ing" section
Refer to the "Fire lighting" section
Refer to the "Fire lighting" section
Refer to the "Openings for convection
air" section
Check the connection points