Whirlpool AR1800XA0 Guía Para Instalación Y Uso página 8

Tabla de contenido

Publicidad

q
Electrical
Requirements
Electrical
Shock Hazard
l
Electrical ground is required on this appliance.
l
Grounding wire must be connected to ground screw
(located in lower right corner of unit) when air conditioner
is in cabinet.
l
If cold water pipe is interrupted by plastic, non-metallic
gaskets, or other insulating materials, DO NOT use it for
grounding.
l
DO NOT ground to a gas pipe.
l
DO NOT modify the power supply cord. If it does not fit
the outlet, have a proper outlet installed by a qualified
electrician.
l
DO NOT have a fuse in the neutral or grounding circuit.
l
DO NOT use an extension cord with this appliance.
l
Check with a qualified electrician if you are unsure
whether the appliance
is properly grounded.
Failure to follow these precautions
could result in electrical
shock, serious injury, or death.
OBSERVE
ALL LOCAL CODES AND ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES,
REMOVE THE
POWER SUPPLY CORD GROUNDING
PRONG.
NOTE: If codes permit, and a separate grounding wire is
used, it is recommended
that a qualified electrician determine
that the grounding path is adequate and not interrupted by
plastic, non-metallic
gaskets, or other insulating materials.
To the right are electrical plug variations.
Choose the plug
that matches your unit's plug. Then, use the chart below to
find the voltage and ampere requirements
for your unit, and
the gauge of copper wire required for the receptacle wiring.
I
PLUG
REQUIREMENTS
COPPER WIRE
1
l
115 vdt (103.5 min.-126.5 max.)
14 gauge
l
O-12 amperes
l
15 amp time-delay fuse or circuit
breaker.
2
l
230 vdt (207 min.-253 max.)
14 gauge
or
l
2301'208 volt (197.6 min.-253 max.)
l
O-12 amperes
l
15 amp timedelay fuse or circuit
breaker.
3
l
230 vdt (207 min.-253 max.)
12 gauge
or
l
23O&O8 volt (197.6 min.-253 max.)
l
O-16 amperes
l
20 amp time-delay fuse or circuit
breaker.
4
l
230 vdt (207 min.-253 max.)
1ogeuge
or
l
230/208 volt (197.6 min.-253 max.)
l
O-24 amperes
l
30 amp timedelay fuse or circuit
breaker.
q
Requerimientos
Ektricos
Rieego de Choque
El6ctrico
l
Este artefacto debe ser puesto a tierra.
l
El alambre de puesta a tierra debe ser conectado al
tornillo de puesta a tierra (situado en la esquina derecha
inferior del artefacto) cuando el acondicionador
de aire
est& en la caja rnetilica.
l
Si la tuberia del agua fria estl interrumpida
con
empaquetaduras
plisticas,
no meMicas
u otros
materiales aisladores.
NO usarla para la puesta a tierra.
l
NO poner a tierra en una tuberia de gas.
l
NO modificar el cable de suministro de energia. Si no
ajusta bien en el tomacorriente,
hater instalar un
tomacorriente
adecuado por un electricista calificado.
l
NO usar un fusible en el circuit0 de puesta a tierra o
neutral.
l
NO SE DEBE USAR UN CABLE DE EXTENSION
CON
ESTE ARTEFACTO.
l
Consultar con un electricista calificado para asegurarse
de que el artefacto esti debidamente
puesto a tierra.
El incumplimiento
de estas precauciones
puede resultar
en choque el&trico,
lesi6n grave o la muerle.
OBSERVAR
TODOS LOS CODIGOS Y REGLAMENTOS
LOCALES.
BAJO NINGUNA CIRCUNSTANCIA
DEBE SACAR LA
CLAVlJA
DE PUESTA A TIERRA DEL CABLE DE
ENERGIA ELECTRICA.
NOTA: Si 10s c6digos lo permiten y se usa un alambre de
puesta a tierra separado, se recomienda
que un electricista
calificado determine si el trayecto de la puesta a tierra es
adecuado y no Bsta interrumpido
por empaquetaduras
plbticas,
no rnet&zas
u otros materiales aisladores.
La ilustraci6n a la derecha muestra varias configuraciones
de
enchufes el6ctricos. Seleccionar
el que corresponda
al
enchufe de su artefacto. Luego usar la tabla que se incluye a
continuacidn
para encontrar 10s requerimientos
de voltaje y
amperes para su artefacto y el calibre del alambre de cobre
requerido para el alambrado
del tomacorriente.
_ .- ..-.-. .-
ENCHUFE
REQUERIMIENTOS
DE COBRE
1
l
115 vdtios (103.5 min.-126.5 m&X.) Calibre 14
l
O-12 amperes
l
Disyuntor o fusible de acctin
ret&dada de 15 amp.
2
l
230 vdtios (207 mh-253 mk)
o
Calibre 14
l
230/206 voltios (197,6 min.-253
mhx.)
l
O-12 amperes
l
Disyuntor o fusible de accidn
ratarclsda de 15 amp.
continlia
en la @gina
10

Publicidad

Tabla de contenido
loading

Tabla de contenido