Important; General Characteristics; Installation And Assembly - Astralpool 73158 Manual De Instalación Y Mantenimiento

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the
safety measures to be implemented for installation and start-up. Therefore, the installer as well
as the user must read the instructions before beginning installation and start-up.
Keep this manual for future reference.
Please follow the instructions below to achieve optimum results from the skimmer:
Prefabricated swimming pool / polyester / liner
IMPORTANT - SAFETY WARNING
• The skimmer can reach a maximum absorption of 20 m³/h.
• It is important that the swimming pool water level covers 3/4 of the skimmer mouth.
• The skimmer must be installed by specialized technical personnel.
• Do not add chlorine or bromine tablets to the skimmer basket.
• The product contains ABS components which could be damaged by chemical substances. Only use PVC adhesive.
The manufacturer accepts no liability for the use of other products such as adhesive sealants, fillers, silicone cements,
mastics, etc.
1. CHECK THE CONTENT OF THE PACKAGE
You will find the following accessories inside the package:
Codes 73158 / 73161
• 1 skimmer
• 2 cartridges
• Skimmer mouth cover
• Installation manual

2. GENERAL CHARACTERISTICS

The skimmer's specific function is to clean dirt from the water sur-
face. For this reason, it is advisable to carry out a preliminary study
of the orientation of your swimming pool before construction and to
orient the skimmer to the prevailing winds.
As a general rule, the skimmer should be placed across the width of
the swimming pool and over the deepest area.

3. INSTALLATION AND ASSEMBLY

WARNING: please note that the skimmer can reach a maximum
absorption of 20 m³/h.
CONCRETE SWIMMING POOL (73158 / 73161):
• Attach the skimmer to the swimming pool wall.
• If necessary, fix the skimmer base to the ground.
• The skimmer has side connections for fitting, if necessary, a suc-
tion nozzle and ensuring a constant flow rate of water to the pump.
They can also be used to hang the skimmer on a wall.
Make the necessary connections to the suction nozzles, fo-
llowing the swimming pool regulations in force in your country. The
nozzles must be installed 2 meters apart and always glued in Ø50
mm tubes.
Concrete swimming pool
Panel swimming pool
Codes 73159* / 73160 / 73162* / 73163
• 1 skimmer
• 1 skimmer mouth
• 1 adhesive kit
• 2 cartridges
• Skimmer mouth cover
• Bag of 25mm screws (A)
• Bag of 32mm screws (B)*
• Installation manual
16 m /h
3
73158
73159
73160
Inlet
Deep cud
Standards to be
followed:
EN-13451-3
EN-16713-2
Installation of
suction inlets or
wall support
*
3 Nozzles and pipes not included with the product
20 m /h
3
73161
73162
73163
Skimmer
Pre-cut die
Ø50
Pump
connection
Ø63
Pre-cut die Ø50
Pool floor