Astralpool 73158 Manual De Instalación Y Mantenimiento página 4

• Skimmer 73158 has 2 side connections, skimmer 73161 has 3 side connections. All the connections are covered but
they are easy to open thanks to the perforation.
• The skimmer cover can be adjusted in height and pivoted, if necessary, to make it flush with the outside edge of the
swimming pool.
PREFABRICATED POOL / POLYESTER / LINER (73159/73162):
• The skimmer should be installed at the back of the swimming
pool.
• A hole of 387x170 mm should be made in the pool beforehand.
We recommend a distance of 25 mm between the top of the swim-
ming pool and the top of the hole.
Put the flange in place and screw it in using the 18 DIN
7982 5.5x25mm (A) or 5.5x32mm (B) screws depending on the
thickness of the pool panel. Check that the skimmer has not been
punctured at the back of the screw housings.
• If necessary, fix the skimmer base to the ground.
• The skimmer has side connections for fitting, if necessary, a suc-
tion nozzle and ensuring a constant flow rate of water to the pump.
They can also be used to hang the skimmer on a wall.
Make the necessary connections to the suction nozzles, fo-
llowing the swimming pool regulations in force in your country. The
nozzles must be installed 2 meters apart and always glued in Ø50
mm tubes.
• Skimmer 73159 has 2 side connections, skimmer 73162 has 3 side connections. All the connections are covered but
they are easy to open thanks to the perforation.
LINER
PANEL SWIMMING POOL (73160 / 73163):
• The panel should have a hole of 425x210 mm.
We recommend a distance of 25 mm between the
top of the swimming pool and the top of the hole.
Standards to be
followed:
EN-13451-3
EN-16713-2
Installation of
suction inlets or
wall support
*
Nozzles and pipes not included with the product
PREFABRICATED POOL CUT PATTERN
Top of pool
25mm
33,8mm
PANEL SWIMMING POOL CUT PATTERN
Top of pool
25mm
425mm
95mm 95mm
4
Pre-cut die
Ø50
Pump
connection
Ø63
Pre-cut die Ø50
387mm
67,5mm 67,5mm
405mm
95mm 95mm
444mm
Pool floor