Installation Instructions; Dimensions; Safety Instructions For Installation; General Notes - Zenner EnergieTechnik multidata WR3 Manual De Instalacion Y Uso

Español Italiano

Installation instructions

Dimensions

Height:
Width:
Depth:
B
Safety instructions for instal-
lation
Read the instructions carefully
right up to the end before starting
personnel. The current laws and
especially EN 1434 part 1+6, (in
interfaces or mains supply the ge-
neral technical rules and the cor-
sensors and temperature sensors
make sure no heating water es-
capes from the pipe
This can cause burns! Close
re installation.

General notes

Calculators for combined heat /
cold meter, you recognize at the
and cooling meter on the imprint
Take care of:
The display must be readable at
all times
other interferences do not install
motors or pumps in the imme-
mum distance 1 m)
-
The ambient temperature must
The type of temperature sensor
must correspond with the calcu-
lator
sor must correspond with the
one from the calculator.
-
-
-
-
21