Wolf ICBMDD30TM Guía De Uso Y Mantenimiento página 12

MICROWAVE OVEN OPERATION
Auto Defrost Guide
NUMBER FOOD AMOUNT
1 Ground Meat 230 g–1.1 kg
2 Steaks, Chops 230 g–1.4 kg
3 Boneless Poultry 230 g–1.1 kg
4 Bone-in Poultry 230 g–1.4 kg
5 Roast 1.1–1.8 kg
|
12 English
METHOD
Remove any thawed pieces after each audible signal. Let stand for 5–10
minutes, covered.
After each audible signal, rearrange. If there are warm or thawed por-
tions, shield with small flat pieces of aluminum foil. Remove any meat
that is almost defrosted. Let stand for 10–20 minutes, covered.
After each audible signal, rearrange pieces or remove should they
become warm or thawed. Let stand for 10–20 minutes, covered.
After each audible signal, rearrange pieces or remove should they
become warm or thawed. Let stand for 10–20 minutes, covered.
Start defrosting with fat side down. After each audible signal, turn over
and shield warm areas with aluminum foil. Let stand for 30-60 minutes,
covered.
CARE RECOMMENDATIONS
Care Recommendations
CLEANING
Stainless steel Use a nonabrasive stainless steel cleaner and apply with a soft lint-free cloth. To bring out the natural
luster, lightly wipe surface with a water-dampened microfiber cloth followed by a dry polishing chamois.
Always follow the grain of stainless steel.
Door Front Spray glass cleaner on a cloth to clean.
Control panel Use spray degreaser to remove fingerprints and food soil. Spray on a cloth before wiping panel.
IMPORTANT NOTE: Do not spray cleaners directly on the control panel.
To lock the control panel before cleaning, refer to page 8.
Interior Wipe with a soft damp cloth. Do not use abrasive or harsh cleaners or scouring pads. For heavier soil,
use baking soda or a mild soap; rinse thoroughly with hot water. Do not use chemical oven cleaners.
Turntable Remove for cleaning. Wash in water with mild soap. For stubborn stains use a mild cleanser and non-
abrasive scouring sponge. Turntable is also dishwasher-safe.
Waveguide cover Located on the inside top of the microwave interior. Carefully wipe with a soft damp cloth. Do not remove
the waveguide cover.