Radio Receiver; Product Description - Nice Spido Instrucciones Y Advertencias Para El Instalador

smxi

Product description

The control unit of the SP6000 already features a radio receiver for
"rolling code" transmitters belonging to the FLOR and VERY VR series
produced by Nice. The special thing about this series is that the
recognition code is different for each transmitter (it also changes every
time it is used). Therefore, in order to allow the receiver to recognise a
determined transmitter, the recognition code must be memorised. This
operation must repeated for each transmitter required to communicate
with the control unit of the SP6000.
Up to a maximum of 256 transmitters can be memorised in the
receiver. No one transmitter can be cancelled; all the codes must be
deleted.
10

radio receiver

During the transmitter code memorisation phase, one of these
options may be chosen:
Type I. Each transmitter button activates the corresponding output
in the receiver, that is, button 1 activates output 1, button 2 activates
output 2, and so on. In this case there is a single memorisation phase
for each transmitter; during this phase, it doesn't matter which button
is pressed and just one memory sector is occupied.
Type II. Each transmitter button can be associated with a particular
output in the receiver, e.g., button 1 activates output 3, button 2
activates output 1, and so on. In this case, the transmitter must be
memorised, pressing the required button, for each output to activate.
Naturally, each button can activate just one output while the same
output can be activated by more than one button. One memory
section is occupied for each button.
The control unit of the SP6000 only uses the first of the 4 receiver
channels, in particular, output N°1 is connected to the "Step-by-step"
output; outputs 2 – 3 – 4 are not used.