Nice Spido Instrucciones Y Advertencias Para El Instalador página 11

Installing the aerial
The receiver requires an ABF or ABFKIT type aerial to work properly;
without an aerial the range is limited to just a few metres. The aerial
must be installed as high as possible; if there are metal or reinforced
concrete structures nearby you can install the aerial on top. If the
cable supplied with the aerial is too short, use a coaxial cable with 50-
Ohm impedance (e.g. low dispersion RG58); the cable must be no
longer than 10 m. Connect the central core of the cable to terminal
Memorising a remote control
!
Warning: when the memorisation phase is activated,
any transmitter correctly recognised within the reception
range of the radio is memorised. Consider this aspect with
care and remove the aerial if necessary to reduce the
capacity of the receiver.
The procedures for memorising remote controls must be performed
within a certain time limit; please make sure you read and understand
the whole procedure before starting.
To carry out the following procedure, use the button on the radio
receiver box (item A, Fig. 1b) and the respective Led (item B, Fig.
1b) to the left of the button.
Table "B1" Memorisation mode I
(each button activates the corresponding output in the receiver)
1. Press and hold down the receiver button for at least 3 seconds
2. Release the button when the Led lights up
3. Within 10 seconds, press button 1 of the transmitter to memorise for at least 2 seconds
N.B.: If the procedure was memorised correctly, the Led on the receiver will flash 3 times.
If there are other transmitters to memorise, repeat step 3 within another 10 seconds
The memorisation phase finishes if no new codes are received for 10 seconds
Table "B2" Memorisation mode II
(each button can be associated with a particular output)
SP6000 can only use output n° 1. Do not use the other outputs, therefore
1. Press and release the button on the receiver
2. Check that the Led flashes
3. Memorise within 10 seconds by pressing the relative
transmitter button for at least 2 seconds
N.B.: If the procedure was memorised correctly, the Led on the receiver will flash 3 times.
If there are other transmitters to memorise, repeat step 3 within another 10 seconds.
The memorisation phase finishes if no new codes are received for 10 seconds.
10 and the earth braid to terminal 9. If the aerial is installed in a place
that is not connected to earth (masonry structures), the braid's
terminal can be earthed to provide a larger range of action. The earth
point must, of course, be local and of good quality. If an ABF or
ABFKIT aerial cannot be installed, you can get quite good results
using the length of wire supplied with the receiver as the aerial, laying
it flat and connecting it to terminal 10.
B
A
1b
Example
RX 3s
RX
2s
TX
x3
Example
RX
2s
TX
x3
GB
11