Pioneer SGX-CA500 Guia De Inicio Rapido página 8

EN
Charging
• It takes about 4 hours to charge
fully (Power off or normal charging).
The device will automatically stop
charging once the battery is 100%
fully charged.
• When the device is turned off, the
screen turns dark after 5 seconds.
To check the battery level, touch the
touch panel or press the [START/
STOP] button.
• For safety reasons, the device
will not charge when outside
the temperature range of 0°C-
45°C. When the devices internal
temperature is too high, full charge
may not be achieved. In this case,
turn off the device, allow it to cool
down and then recharge it.
• Connect the provided USB cable
directly to the USB port of your PC.
If the device is connected via a USB
hub, it may not charge to full capacity.
Make sure that the USB output of
your PC accepts 5V/500 mA.
• Do not unplug the USB cable, shut
down the PC or use sleep mode
while the device is transferring data
as it may corrupt the data in the
device.
8
4
Unplug the USB cable from the
USB port.
Once data transfer is complete and the
battery is fully charged, disconnect the
USB cable from the PC first, then from
the device.
5
Close the USB connector cover.
To ensure water resistant performance,
firmly close the USB cover.