Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Converting to LP Gas (continued)
if It Is This Regulator:
Gas Flow
Do not
removethis
except for
cortve rsion
Lever shown closed
PULL TO OPEN
Cap Assembly
1. Unscrew
the plastic-protected
hexmut
cap from the
regulator°
2. Carefully
pry the
protective
plastic
cap
off the
threaded
metat cap. Gently pull the plastic
washer
off the threads
on the other side of the metal cap.
3. Push the plastic cap onto the end of the metal cap
displaying
the type of gas you are converting
to.
Press the attached
plastic washer onto the threads
on the other side of the metal cap,
4. Screw the hex-nut
cap back into the regulator_ Do
not overtighten,,
Step 2
Converting
The Surface Burners
Follow the directions
in A for Sealed
Burner
Models
(models
without
lift-up cooktops)
or B for Standard
Twin Burner Models (models
with lift-up cooktops),
A Sealed Burner Models
(models without lift-up cooktops)
m
3.
Remove
the brass orifice spud
f/,__j
inside
the
chimney
of
each
burner
using
a 9/32"
or 7 mm
_
nut driver,
Install the orifice spuds accord-
Ch_mn
ing to one of the following
dia-
grams
(see [] or F_) for LP gas
or natural
gas,
depending
on
which you are converting
to.
Orifice Spud
[_] Orifice
Spuds for Converting
to LP Gas:
LP orifice spuds are in a small plastic bag packed with
this Use and Care Manual,
LP orifice spuds have a 2-
digit
number
and the letter "L" on top,, Each orifice
spud
will also
have
1, 2 or 3 grooves
on the top,
denoting
the location
on the range where
it is to be
installed
as shown be!ow,
Front of Range
[_
Orifice
Spuds
for Converting
to Natural
Gas:
Natural
gas orifice spuds have a 3-digit
number
and
the letter "N" on the top, Each orifice
spud will also
have
1, 2 or 3 grooves
on top denoting
the location
on the range
where
it is to be installed
as shown
below°
Grate
Burner Cap
_
Drip Pan (on some models)
Burner Head
\ i_
Electrode
1. Remove
grates,
burner
caps
and burner
head&
4. To prevent
leakage,
make sure the orifice
spuds
are securely
screwed
into the gas inlet tube&
5. Put old orifice
spuds back in the bag to save for
possible
future conversion.
NOTE:
If an orifice spud is acci-
dentally
dropped,
the cooktop
can be raised by disengaging
the
2 front clips with a large flat blade
screwdriver°
When lowering
it, make sure it snaps over the clips
44
Publicidad
Tabla de contenido
