Kenmore 75361 Manual De Uso página 48

THE PROBLEM SOLVER coot ouedl
PROBLEM POSSIBLE CAUSE
SURFACE BURNERS
LIG HT BUT OVEN
DOES NOT
o The oven gas shut off valve may have accidentally been moved during
cleaning or moving.
To check the oven gas shut off valve on standard twin burner models, raise
the cooktop and look for the gas shut off lever at the extreme right rear corner.
Follow the directions in box A or B that match your regulator type.
Lever shown closed/
Standard Twin Burner Models
Lever shown closed /
Standard Twin Burner Models
To check the oven gas shut off valve on sealed burner models, remove
the storage drawer, broiler drawer or kick panel and look for the gas shut
off lever at the back of the range. On some models you may have to
remove an access cover also.
, j )
Sealed Burner Models
OVEN WILL NOT o Oven temperature is too high to set self-cleaning operation.
SELF-CLEAN Allow the range to cool to room temperature and reset the controls,
• Door latch handle not moved all the way to the right.
OVEN DOOR WILL ° The oven must cool below the locking temperature after the clean cycle
NOT UNLOCK is complete. Do not lock door with door latch except when using the
self-clean feature or the oven may lock.
DOOR ACCIDENTALLY • Turn the OVEN TEMP knob to OFF.
LOCKED WHILE BAKING
OVEN NOT CLEAN AFTER • Oven controls not set properly. See the Operating the Self-Cleaning
CLEAN CYCLE Oven section.
• Heavily soiled ovens require 3½ to 4 hours of cleaning time°
• Heavy spillovers should be cleaned up before starting clean cycle.
SURFACE LIGHT • Fluorescent bulb is loose or defective. Adjust or replace,,
DOES NOT WORK • Switch operating light is broken. Cal! for service.
48