Baby Unit Power Supply - miniland baby digimonitor 3.5 plus Manual Del Usuario

en
When the battery charging level is very low, the message "LOW BATTERY" will be
displayed on the screen and the battery level icon (e) will be shown in red. Furthermore,
the left-hand side of the on/link LED (1) will flash red for a few seconds before the monitor
goes off.
Note: remove the battery when the appliance is not going to be used for a prolonged
time period.

5.1.2. BABY UNIT POWER SUPPLY

The camera or baby unit of this baby monitor is designed for use with the battery or with
the AC/DC adapter supplied.
1. Place the connector socket (VI) at the rear of the baby unit.
2. Connect the adapter cable to the mini-USB socket of the camera. Only use the adapter
supplied.
3. Plug in the adapter to the mains.
Warning: Danger of Strangulation – Keep the cable out of reach of the baby. NEVER
place a camera with cables less than 1 metre away from the cot. Never use extension
cables with AC adapters. Only use the AC adapters supplied.
5.2. OPERATION
5.2.1. TURNING THE UNITS ON/OFF
5.2.1.1. MONITOR:
Keep the on button pressed (4) situated on the upper part of the monitor to turn it on and
off. The on/link LED indicator (1) will go on and off depending on whether you turn the unit
on or off.
5.2.1.2. CAMERA:
To turn the camera on or off, keep the on button (II) pressed in for two seconds. The power
LED (VII) will go on and off depending on whether you turn the unit on or off.
When you have installed the camera and turned it on, you can see the images and listen to
the sounds captured in your baby's room via the monitor.
5.2.2. MONITOR VOLUME
Press the set button ▲ (7) if you wish to increase the volume of your monitor or the set
button ▼ (9) if you wish to turn it down, choosing between the 6 levels available.
5.2.3. TALK TO THE BABY
You may talk to your baby from the parents' unit (for example, to calm it down and so it
understands you'll be with it in a moment) or to your partner (if he or she is in the baby's
room).
Press the button and keep it pressed in to talk to the baby (11) and talk in front of the
monitor. Release the button when you have finished talking to listen to the sound from the
baby's room again.
Bear in mind that you can't listen to your baby whilst you're talking to it; to listen to it, you
will have to stop pressing this button.